To configure the ATM interface on Nokia Platform A
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Select
3.Enter 93 in the VCI text box in the Create a new LLC/SNokia Platform RFC1483 interface section.
The channel number of the interface is no longer the VCI number but an automatically allocated number. Therefore, the logical name of the interface in step 6 is something that depends on what other logical ATM interfaces there are. Find the newly created interface from the table before you continue.
4.Click Apply.
5.Click
6.Enter 192.168.3.2 in the Local Address text box.
7.Enter 192.168.3.1 in the Remote Address text box.
8.Click Apply
9.Enter 9180 in the IP MTU text box.
10.Click Apply.
11.Click Save.
Note
The steps for configuring the ATM interface on Nokia Platform B are the same except that you should set the to 52 when you create the logical interface and reverse the IP addresses should be reversed.
IP over ATM (IPoA)
To configure an ATM logical IP subnet (LIS) interface
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Click the physical interface link to configure in the Physical column. Example:
3.Select SONET or SDH as the framing format in the Physical Configuration table.
The setting should match the type of transmission network to which the interface is connected.
4.Select Freerun or Loop Timing as the transmit clock choice in the Physical Configuration table.
Freerun uses the internal clock. If two ATM interfaces are directly connected, at least one of them must use the internal clock.
Nokia Network Voyager for IPSO 4.0 Reference Guide | 79 |
