IGMP Snooping Commands 489
no ip igmp snooping fast-leave
•

vlan id

— Number assigned to the VLAN.
Default Configuration
IGMP snooping fast-leave mode is disabled on VLANs by default.
Command Mode
VLAN Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables IGMP snooping fast-leave mode on VLAN 2.
console(config-vlan)#ip igmp snooping fast-leave 2
ip igmp snooping groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN.
The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface
before deleting the interface from the entry. This value must be greater than
the IGMPv3 Maximum Response time value. The range is 2 to 3600 seconds.
The no form of this command sets the IGMPv3 Group Membership Interval
time to the default value.
Syntax
ip igmp snooping groupmembership-interval
vlan-id seconds
no ip igmp snooping groupmembership-interval
•

vlan-id

— Number assigned to the VLAN
• seconds — IGMP group membership interval time in seconds. (Range:
2–3600)
2CSPC4.XCT-SWUM2XX1.book Page 489 Monday, October 3, 2011 11:05 AM