MMB
CHAPTER 3
Table 3.43 Displayed and setting items in the [MMB#x] window
Item |
| Description |
Status | MMB status: | |
| • | OK: Operating normally |
| • Not present: Not installed | |
| • | Degraded: Component failure (The faulty component can be |
|
| isolated to continue operation.) |
| • | Failed: Failure |
|
| |
Role | MMB operation status: | |
| • | Active: Operating |
| • | Standby: Standby mode |
| • Disabled: Set to the | |
|
| |
Part Number | MMB part number | |
Serial Number | MMB serial number | |
MAC address | MAC address of the MMB management port. | |
Firmware Version | MMB firmware version | |
Location LED | Location LED status | |
| The three light statuses are as follows: | |
| • | On: Currently lit |
| • Off: Currently not lit | |
| • | Blink: Currently blinking |
| The LED can be turned on, turned off, or set to blink by clicking a | |
| radio button. | |
|
| |
Reset MMB | Check this check box to reset the MMB. | |
| If this check box is checked, the [Switch Over to MMB] check box | |
| described below cannot be checked. | |
|
| |
Switch Over to MMB | Check this check box to toggle between the active and standby | |
| modes of the MMB. | |
| If this check box is checked, the [Reset MMB] check box | |
| described above cannot be checked. | |
| Note: This field is displayed only if two MMBs are installed. | |
|
| |
Enable/Disable MMB | This field can be used to enable and disable the MMB. | |
| • Enable: Places the added MMB in standby state. | |
| • Disable: Disables the MMB. | |
| When an MMB is added to the | |
| initial status is disabled. The MMB already operating in the | |
| machine has the active status. To place the added MMB in the | |
| standby status, enable it by using this field. | |
|
|
|
Voltage |
|
|
Sensor | Voltage sensor type | |