GSWB
CHAPTER 8 CLI Operations
•Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again, collect unit information, configuration definition information, and the information in different types of logs, and restart the unit. Alternatively, contact a certified service engineer.
• vlan id doesn’t exist.
Cause: The specified VLAN does not exist.
Action: Reenter the command after creating a VLAN.
• Input parameter error.
Cause: The VLAN specification is invalid.
Action: Review the VLAN specification.
• Invalid switchport mode.
Cause: The VLAN membership mode is not access.
Action: Reenter the command after changing the mode to access.
•It is necessary to review specified VLAN and port.
Cause: The VLAN and port definition do not match.
Action: Review the VLAN and port definitions.
8.2.9.5switchport native vlan
This command specifies a VLAN to be allocated to traffic without tags:
zThe VLANs that can be used in Trunk mode are determined by this command and the switchport allowed vlan command.
zTrunk mode must be set before this command is executed. If the command is executed in Access mode, no error message is displayed and no setting is made.
zThe default setting is "switchport native vlan 1".
zTagged frames of the VLAN specified by this command are also received. However, VLAN frames specified by the command are sent without tags.
When making this setting for a