GSWB 8.2 Configuration Definition Commands
Switch(config)# interface GigabitEthernet 0/4
• Sets 500 as the path cost for a
Switch(config)# interface
(6)Error Messages
•% Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
•Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again, collect unit information, configuration definition information, and the information in different types of logs, and restart the unit. Alternatively, contact a certified service engineer.
• Input parameter error.
Cause: An invalid parameter was specified.
Action: Specify the correct parameter.
8.2.8.8spanning-tree bpdufilter
This command defines the BPDU filter. Enabling the BPDU filter on a specific interface is equivalent to disabling the spanning tree on the interface, and a spanning tree loop may be formed as a result. The spanning tree must be disabled before the BPDU filter is enabled.