GSWB

CHAPTER 8 CLI Operations

-notification: TCN BPDU transmission interval when a topology change is detected

This value is the same as the hello time.

-hello: Config BPDU transmission interval

If this unit is operating as the root bridge, the setting of this unit is reflected. If this unit is operating as a non-root bridge, the value set in the Config BPDU frame reported from the root bridge is reflected.

-max age: Maximum aging time

If this unit is operating as the root bridge, the setting of this unit is reflected. If this unit is operating as a non-root bridge, the value set in the Config BPDU frame reported from the root bridge is reflected.

-forward delay: Transfer delay time

If this unit is operating as the root bridge, the setting of this unit is reflected. If this unit is operating as a non-root bridge, the value set in the Config BPDU frame reported from the root bridge is reflected.

zConfigured Times: Settings based on the configuration definition

-hello: Config BPDU transmission interval (1 to 10)

-max age: Maximum aging time (6 to 40)

-forward delay: Transfer delay time (6 to 40)

zTimers: Timer operating status flag (ACTIVE or INACTIVE)

-hello: Hello time timer

"ACTIVE" is displayed when the hello time timer is operating, and "INACTIVE" is displayed when it is not operating. If this unit is operating as the root bridge, the hello time timer is operating because BPDU frames are transmitted from this unit.

If this unit is operating as a non-root bridge, the hello time timer is not operating because BPDU frames received from the root bridge are transferred. Therefore, "INACTIVE" is always displayed when this unit is operating as a non-root bridge.

zbpdu filter: BPDU filter setting status (ON/OFF)

This item is displayed only if the STP status is Disable.

-on: Enables the bpdu filter (enable: Transfer bpdu frames)

-off: Disables the bpdu filter (disable: Do not transfer bpdu frames)

8-236

C122-E003-02EN