GSWB
CHAPTER 8 CLI Operations
8.2.13Port mirroring functions
8.2.13.1 monitor session source
This command specifies the monitored ports. However, no setting can be made for a
A change only to the defined traffic direction is not possible. A reset is required after an entry is deleted. Any interface specified by the monitor session destination command cannot be registered.
The show monitor session source command can be used to check registered entries. If no entry is registered, nothing is displayed.
By default, no entry is registered.
(1)Synopsis
•Specifies a monitored port
monitor session source interface
• Removes a monitored port from port monitoring
no monitor session source interface
(2) Options
z
Specifies the source interface (GigabitEthernet 0/1 to 0/8, IO_Units 00 to 71, 10GigabitEthernet 1/1 to 1/2, ports 1 to 26).
zrx tx both (optional)
Specifies the traffic direction. The default setting is [both].
-rx: Incoming
-tx: Outgoing
-both: Bidirectional
(3)Command mode
Global