PSA
CHAPTER 5
Item |
| Description |
Boot Watchdog |
|
|
Watchdog | The user can enable or disable Boot Watchdog monitoring: | |
| • | Disable: Disable monitoring |
| • | Enable: Enable monitoring |
| The default setting is [Disable]. | |
|
| |
TimeOut | The user can specify a timeout value in seconds, which is used | |
| while Boot Watchdog monitoring is enabled: | |
| Range: 60 to 6000 seconds | |
| Specify a value calculated based on the period of time from the | |
| time the partition is switched on to the time the console/Syslog | |
| receives a startup completion message (the console displays | |
| Starting PSA services: [OK] or Starting PSA services: [OK] or | |
| Syslog includes "FJSVpsa: I00069 PM startup succeeded"). | |
| Fujitsu recommends setting a value that is at least twice this | |
| elapsed time in order to prevent mistaken detection. Also, | |
| consider the time taken to save a dump in the event of an OS panic. | |
| You can only specify this item if you select [Enable]. The default | |
| value is 0 seconds. Note that you always need to change the | |
| default value. | |
|
|
|
| Table 5.35 Buttons in the [Watchdog] window | |
|
|
|
Button |
| Description |
Apply |
| Click the [Apply] button to set the values entered for Watchdog |
|
| monitoring. Clicking this button validates the settings for both |
|
| Software Watchdog and Boot Watchdog. |
|
|
|
Cancel |
| Click the [Cancel] button to clear the entered values and revert to |
|
| the original settings. |
|
|
|
(1) Menu operation
[Partition] → [Partition #x] → [PSA] → [Setup] → [Watchdog]
(2)GUI operation
•Setting up Watchdog monitoring (when correct values are entered)
1Select and enter values for the Watchdog monitoring settings, and click the [Apply] button.
If the entered values are correct, the [Confirm Settings] dialog box opens.