GSWB
CHAPTER 8 CLI Operations
• Uses the show command to check settings
Switch(config)#
Switch(config)#ldap server 10.10.10.10 Switch(config)#ldap server 10.10.10.11 Switch(config)#show ldap server
ldap server 10.10.10.10 ldap server 10.10.10.11 Switch(config)#
(6)Error Messages
•% Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
•Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again, collect unit information, configuration definition information, and the information in different types of logs, and restart the unit. Alternatively, contact a certified service engineer.
• Input parameter error.
Cause: An invalid IP address was specified.
Action: Enter the correct IP address.
• Input parameter duplicate error.
Cause: An LDAP server already registered was specified.
Action: Check the LDAP servers already registered.
• Set count over.
Cause: Registration exceeding the maximum 2 units was attempted.
Action: Check the number of registered entries.