GSWB 8.2 Configuration Definition Commands
(4) See also
monitor session destination
(5)Examples
•Sets GigabitEthernet 0/1 as a monitored port
Switch(config)# monitor session source interface GigabitEthernet 0/1 both Switch(config)#
• Deletes GigabitEthernet 0/1 from the monitored ports
Switch(config)# no monitor session source interface GigabitEthernet 0/1 Switch(config)#
• Uses the show command to check settings
Switch(config)# show monitor session source Switch(config)#
Switch(config)# monitor session source interface GigabitEthernet 0/1 both Switch(config)# monitor session source interface GigabitEthernet 0/2 rx Switch(config)# monitor session source interface GigabitEthernet 0/3 tx Switch(config)# show monitor session source
monitor session source interface GigabitEthernet 0/1 both monitor session source interface GigabitEthernet 0/2 rx monitor session source interface GigabitEthernet 0/3 tx Switch(config)#
(6)Error Messages
•% Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
•Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again, collect unit information, configuration definition information, and the information in different types of logs, and restart the unit. Alternatively, contact a certified service engineer.