GSWB 8.2 Configuration Definition Commands
• Input parameter error.
Cause: An invalid parameter was entered.
Action: Enter the correct parameter.
• Command is already running.
Cause: One of the following commands is running. restore config / save / save config / clear config
Action: Reexecute after exiting the command.
8.2.1.4save config
This command copies the configuration definition file to the work area. If the work area contains a file with the same name (config0, config1), the existing file is overwritten.
Note: This command cannot be executed during execution of the clear config, clear ramdisk, restore config, save, save config, or tftp command.
(1)Synopsis
•Copies the configuration definition file to the work area
save config [{config0 config1}]
(2) Options
z{config0 config1} (optional)
-config0: Specifies config0.
-config1: Specifies config1.
By default, the configuration definition file of the booting memory bank is copied to the work area.
(3)Command mode enabled exec
(4)See also
clear config
clear ramdisk
restore config