PSA
CHAPTER 6 CLI Operations
6.8SNMP Security Setting Command (setsnmpsec)
The setsnmpsec command sets SNMP service security (sets the host that accepts SNMP packets). If the SNMP service security setting is "Accept SNMP packets from any host." you do not need to execute this command.
If the MMB IP address is changed after PSA installation in an environment where the SNMP service security setting is "Accept SNMP packets from any host," execute this command when the SNMP service security setting is changed from "Accept SNMP packets from any host" to "Accept SNMP packets from these hosts."
(1) Synopsis
setsnmpsec
(2)Options
None
(3)Example
>setsnmpsec
(4)Output messages
•Normal termination
FJSVpsa : I 04200 Security setting for SNMP Service was completed.
• Abnormal termination
FJSVpsa : E 04201 Anerror occurred at the time of security setting for SNMP Service.
(5) NotesAfter you execute this command, you need to restart the SNMP Service.