CHAPTER 4 — PROGRAMMABLE FUNCTION STRINGS Page 4-25

LANDMAN

Use manual feed paper (sheet feed). If the System specifies manual feed with the SCS Printer Setup command, and if the printer is in landscape mode, this PFS will be sent to the printer. If the printer has more that four paper drawers, this PFS can be used to access a fifth or sixth drawer. However, automatic orientation selection works only for (P/L) PAPER 1>, (P/L) PAPER 2>, (P/L) PAPER 3>, and (P/L) ENVEL>. It does not work for LANDMAN>.

JOG OUT

Move paper output tray to the other position (when the printer can output paper to two positions). This is sometimes referred to as output offsetting. This PFS is sent to the printer at the beginning of each page that requires an offset when the System has sent an SCS Set Initial Conditions command with the ic parameter set to FFh (DP), when the System has sent an SCS Page Presentation Media command with the do parameter set to a value other than 00h, or when the System has sent an SCS Page Presentation Media command with the dd parameter changed from its last setting.

DEST1

Select paper output drawer 1. This PFS is sent to the printer at the beginning of each page when the System has selected paper output tray number 1 with the SCS Page Presentation Media command.

DEST2

Select paper output drawer 2. This PFS is sent to the printer at the beginning of each page when the System has selected paper output tray number 2 with the SCS Page Presentation Media command.

DEST3

Select paper output drawer 3. This PFS is sent to the printer at the beginning of each page when the System has selected paper output tray number 3 with the SCS Page Presentation Media command.

JSTSTRT

Start justification if the printer is capable of text justification. The user must select the PRINTER setting for JUSTTYP= (under FMTINFO: for the output port) for the OPTIMA to use this PFS.

Page 124
Image 124
Agilent Technologies 5250 user manual Landman, Jog Out, DEST1, DEST2, DEST3, Jststrt