Page viiPREFACE
FCC Statement
This equipment generates, uses and can radiate radio frequency energy. If
it is not installed and used in strict accordance with AGILEs instructions,
it may cause interference to radio and television reception. This equipment
has been tested and complies with the limits for a Class A computing
device in accordance with the specifications in Subpart J of Part 15 of FCC
Rules, which are designed to provide reasonable protection against such
interference when operated in a commercial environment. Operation of
this equipment in a residential area is likely to cause interference.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio
and television reception, which can be determined by turning the
equipment off, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient the receiving antenna.
Relocate the OPTIMA with respect to the receiver.
Move the OPTIMA away from the receiver.
Plug the OPTIMA into a different outlet so that the OPTIMA and
receiver are on different branch circuits.
If necessary, the user should consult an experienced radio/television
technician for additional suggestions. The booklet, How to Identify and
Resolve Radio-TV Interference Problems, prepared by the Federal
Communications Commission, may also be helpful. This booklet is
available from the US Government Printing Office, Washington, DC
20402, Stock No. 004-000-00345-4.
WARNING: This equipment has been certified to comply with the limits for
a Class A computing device, pursuant to Subpart J of Part 15 of FCC
rules. Only peripherals (computer input/output devices, printers, plotters,
etc.) certified to comply with the Class A (commercial) or Class B
(residential) limits may be attached to the OPTIMA. Operation with non-
certified peripherals is likely to result in interference to radio and TV
reception.
Note: This equipment uses shielded cables to meet compliance limits for a
Class A computing device. Shielded cables must be used to ensure this
equipment continues to meet these limits. The shield must be terminated to
the metallic connector at both ends to guarantee adequate suppression of
undesirable emissions. All cables are double shielded (Mylar foil and
tinned copper braid.)