Page | AGILE 5250 OPTIMA User’s Guide and Reference |
|
|
Command: | Justify Text Field (JTF) |
Format: | 2B D2 nn 03 rere pr |
Printers: | 3812, 5219 |
Action: | Specifies that a field of text is to be justified. |
| Text to be justified follows the command. Justification |
| ends at the next Justify Text Field (JTF), Carriage Return |
| (CR), New Line (NL), Required New Line (RNL), |
| Interchange Record Separator (IRS), Form Feed (FF) or |
| Required Form Feed (RFF) command. |
| The left edge of the field’s placement is the current print |
| position. |
| The rere parameter specifies the right edge the field’s |
| placement in |
| margin. |
| The pr parameter specifies the percentage of white space |
| at the end of the field that is to be redistributed within the |
| field. |
| Allowed values of pr for 3812 and 5219 printers are 00h |
| (no change from last value), 32h (50%) and 64h (100%). |
| If the text to be justified does not fit within the field, no |
| justification takes place. |
| JFT cannot occur while Set Justify Mode is active. |
IBMEMUL: | Same as IBM. |
| The OPTIMA allows any percentage rule: 00h (no |
| change), and 01h (1%) to 64h (100%). |
| The OPTIMA turns off justify mode (as set by Set Justify |
| Mode) upon receiving this command. |
| The OPTIMA performs all calculations necessary to |
| perform the justification on the target printer. Because of |
| the complexity of these calculations, justification may |
| result in significantly reduced throughput. |
| The OPTIMA sends the PFS SNDXTRA> to the printer |
| between the characters in the text field to place small |
| amounts of additional space between the characters. This |
| results in the text being justified. |
275EMUL: | No operation. |
