CHAPTER 1 — GETTING STARTED

Page 1-25

7.Press d thirteen times. The display should read: SERIAL1: BAUD=

8.Press g. The display should read:

BAUD= setting

where setting is the default baud rate for the printer.

9.If the baud rate shown is not correct, use d and f to select the proper setting. When the baud rate is set, press ENTER. The display should scroll to the right to read:

SERIAL1: BAUD=

10.Press f. The display should read: SERIAL1: PARITY=

11.Press g. The display should read: PARITY= setting

where setting is the default parity setting for the printer.

12.If the parity setting shown is not correct, use d and f to select the proper setting. When the parity setting is set, press ENTER. The display should scroll to the right to read:

SERIAL1: PARITY=

13.Press f. The display should read: SERIAL1: LENGTH=

14.Press g. The display should read: LENGTH= setting

where setting is the default word length (number of data bits) setting for the printer.

15.If the length shown is not correct, use d and f to select the proper value. When the length is set, press ENTER. The display should scroll to the right to read:

SERIAL1: LENGTH=

16.Press f. The display should read: SERIAL1: STOPS=

Page 50
Image 50
Agilent Technologies 5250 user manual SERIAL1 BAUD=, SERIAL1 PARITY=, SERIAL1 LENGTH=