Agilent Technologies 5250 user manual Logical page of the next job are not printed on the same

APPENDIX B — SCS/DCA COMMAND SUMMARY		Page B-21
	logical page of the next job are not printed on the same
	physical page.
	When the OPTIMA is calculating automatic page
	orientation, the setting of the initial condition set
	determines how page size will be calculated. If the ic
	parameter is set to 01h (Word Processing), then the page
	size is determined by the settings of the last received Set
	Presentation Page Size (SPPS) command. If the ic
	parameter is set to FFh (Data Processing), then the page
	width is determined by Maximum Print Position (MPP)
	divided by CPI, and the page height is determined by
	Maximum Print Line (MPL) divided by LPI.
275EMUL:	The system-changeable parameters supported by the 275
	are set to their default values.
Command:	Set Horizontal Tabs (STAB)
Format:	2B D2 nn 01 ff a1 tab1 a2 tab2 a3 tab3…
Printers:	3812, 5219
Action:	Sets horizontal tab characteristics and positions.
	The ff parameter specifies the type of tab stops. If the ff
	parameter value is 00h, the tab stops are column
	(floating) positions. If the ff parameter value is 01h, the
	tab stops are fixed positions.
	The a1 and a2 parameters are not used but must be
	present. All tab stops are specified by sets of three bytes
	each.
	The tab1 and tab2 parameters are either column or fixed
	positions. For floating tabs, the tab1 and tab2 parameters
	are the column numbers relative to the left margin. For
	fixed tabs, the tab1 and tab2 parameters are the tab
	positions in 1/1440-inch units relative to the left margin.
	If this command specifies no tab positions, all current tab
	positions are cleared.
IBMEMUL:	Same as IBM.
275EMUL:	No operation.