![](/images/new-backgrounds/1230151/230151431x1.webp)
APPENDIX B — SCS/DCA COMMAND SUMMARY | Page | |
IBMEMUL: | Same as IBM, except that the OPTIMA will perform | |
| COR even if it has been disallowed with this command. |
The OPTIMA uses the fc and sd parameters to select a source paper drawer simply by adding two (2) to the sd parameter if a
The OPTIMA will send one of the PFSs PPAPER1>, PPAPER2>, PPAPER3>, P ENVEL>, LPAPER1>, LPAPER2>, LPAPER3>, L ENVEL> at the beginning of each page. For target printers that force a page eject when a paper source is selected, it may be necessary to delete the PFS FF> and rely on these PFSs to perform form feeding. For printers that do not force a page eject when selecting a source drawer, the FF> PFS should be left unmodified (usually containing only 0Ch).
Although source drawer 4 is called ENVELOP, there is no reason that this drawer needs to contain envelopes. Similarly, there is no reason that PAPER 1, PAPER 2 and PAPER 3 need to hold paper.
The PFS JOGOUT> is sent to the target printer by the OPTIMA at the beginning of each page that requires an output tray offset (jog), either because the do parameter was
The JOGOUT> PFS is also sent to the printer if the Set Initial Conditions (SIC) command specifies the Data Processing (DP) initial condition set. This is the same as the 3812.
The OPTIMA supports dd (destination drawer) parameters of 00h (no change), and the range of 01h through 03h. One of the PFSs DEST1>, DEST2> or DEST3> is sent to the target printer at the beginning of each page. These PFSs can be used to select a destination (output) drawer.