Agilent Technologies 5250 user manual B-20

Page B-20	AGILE 5250 OPTIMA User’s Guide and Reference
Command:	Set Initial Conditions (SIC)
Format:	2B D2 nn 45 ic
Printers:	3812, 5219
Action:	This command resets all system-changeable settings to
	one of two sets of default values.
	The ic parameter specifies the initial condition of the
	printer’s settings. An ic value of FFh specifies the Data
	Processing condition set (DP); an ic value of 01h
	specifies the Word Processing condition set (WP).
		DP	WP
	Page Width	13.2 inches	8.5 inches
	Page Height	11 inches	11 inches
	Left Margin	none	1.5 inches
	Right Margin	13.2 inches	7.5 inches
	Top Margin	none	1 inch
	Bottom Margin	11 inches	none
	Typestyle (GFID)	11	87
	Lines Per Inch	6	6
	Auto New Line	On	Off
	Auto New Page	On	Off
	An ic value of FFh also specifies a job boundary.
	On the 3812, an ic parameter value of FFh causes the
	output tray to be jogged (offset).
IBMEMUL:	Same as the 3812.

When the OPTIMA receives this command with the ic parameter set to FFh, it sends the PFS JOGOUT> to the target printer. This PFS is usually used to jog (offset) the output paper tray.

Besides the target printer settings that are reset by this command, the OPTIMA also sends the PFS JOBSTRT> to the target printer if the ic parameter is set to FFh (DP). By default this PFS is unused. It can be used to reset duplex or 2-up print modes at the target printer, ensuring that the last logical page from one job and the first