CHAPTER 4 — PROGRAMMABLE FUNCTION STRINGS Page 4-23
P ENVEL
Use paper from source/drawer 4. This PFS is sent to the printer at the beginning of each portrait page when the System has sent an SCS Page Presentation Media command with the sd parameter set to 04h. It uses format information from ENVELOP: under FMTINFO: for the port.
PORTCUT
Use cut feed paper (sheet feed). PORTCUT> and LANDCUT> are the only settings allowed by the System if the printer is configured as an IBM 3812 laser printer. If the System specifies cut feed paper with the SCS Set Printer Setup command, and if the printer is in portrait mode, then this PFS will be sent to the printer. Afterward, one of the
PORTTRC
Use tractor feed paper. If the System specifies tractor feed with the SCS Set Printer Setup command, and if the printer is in portrait mode, then this PFS will be sent to the printer. If the printer has more that four paper drawers, this PFS can be used to allow access to a fifth paper drawer. However, automatic orientation selection works only for (P/L) PAPER 1>, (P/L) PAPER 2>, (P/L) PAPER 3>, and (P/L) ENVEL>. It does not work for PORTTRC>.
PORTMAN
Use manual feed paper (sheet feed). If the System specifies manual feed with the SCS Set Printer Setup command, and if the printer is in portrait mode, then this PFS will be sent to the printer. If the printer has more that four paper drawers, this PFS can be used to allow access to a fifth or sixth paper drawer. However, automatic orientation selection works only for (P/L) PAPER 1>, (P/L) PAPER 2>, (P/L) PAPER 3>, and (P/L) ENVEL>. It does not work for PORTMAN>.
LPAPER 1
Use paper from source/drawer 1. This PFS is sent to the printer at the beginning of each landscape page when the System has sent an SCS Page Presentation Media command with the sd parameter set to 01h. It uses format information from PAPER 1: under FMTINFO: for the port.