Agilent Technologies 5250 user manual B-32

Page B-32	AGILE 5250 OPTIMA User’s Guide and Reference
	The qq parameter controls the print quality at the target
	printer by sending one of the PFSs LOWQUAL>
	(qq=03h), MEDQUAL> (qq=01h) or HIQUAL> (qq=02h).
	These PFSs are sent to the printer only if the print quality
	setting is changed. Many target printers (specifically dot
	matrix) place limitations on print quality, proportional
	spacing, font and/or print enhancement combinations.
	The OPTIMA supports the dx (duplex) parameter by
	sending the SIMPLEX>, DUPLEX> or TUMBLE> PFSs
	to the target printer whenever the parameter is changed.
275EMUL:	No operation.
Command:	Set Vertical Margins (SVM)
Format:	2B D2 nn 49 tmtm bmbm
Printers:	3812, 5219
Action:	Specifies top and bottom margins for subsequent pages.
	The tmtm parameter specifies the top margin in 1/1440-
	inch units. Valid values are 0000h through 7FFFh. A
	value of 0000h causes no change to the last setting.
	The bmbm parameter specifies the bottom margin in
	1/1440-inch units. This parameter is not used by 3812 or
	5219 printers.
IBMEMUL:	Same as IBM.
	When in Computer Output Reduction (COR) mode, a
	default half-inch margin is added to the top margin
	requested by the system.
275EMUL:	No operation.