AGILE 5250 OPTIMA User’s Guide and ReferencePage 4-24
LPAPER 2
Use paper from source/drawer 2. This PFS is sent to the printer at the
beginning of each landscape page when the System has sent an SCS Page
Presentation Media command with the sd parameter set to 02h. It uses
format information from PAPER 2: under FMTINFO: for the port.
LPAPER 3
Use paper from source/drawer 3. This PFS is sent to the printer at the
beginning of each landscape page when the System has sent an SCS Page
Presentation Media command with the sd parameter set to 03h. It uses
format information from PAPER 3: under FMTINFO: for the port.
L ENVEL
Use paper from source/drawer 4. This PFS is sent to the printer at the
beginning of each landscape page when the System has sent an SCS Page
Presentation Media command with the sd parameter set to 04h. It uses
format information from ENVELOP: under FMTINFO: for the port.
LANDCUT
Use cut feed paper (sheet feed). PORTCUT> and LANDCUT> are the only
settings allowed by the System if the printer is configured as an IBM 3812
laser printer. If the System specifies cut feed paper with the SCS Printer
Setup command, and if the printer is in landscape mode, then this PFS will
be sent to the printer. Afterward, one of the drawer-select PFSs above will
be sent to select the paper source drawer.
LANDTRC
Use tractor feed paper. If the System specifies tractor feed with the SCS
Printer Setup command, and if the printer is in landscape mode, then this
PFS will be sent to the printer. If the printer has more that four paper
drawers, this PFS can be used to allow access to a fifth paper drawer.
However, automatic orientation selection works only for (P/L) PAPER
1>, (P/L) PAPER 2>, (P/L) PAPER 3>, and (P/L) ENVEL>. It does
not work for LANDTRC>.