Page | AGILE 5250 OPTIMA User’s Guide and Reference |
17.Press g. The display should read: STOPS= setting
where setting is the default number of stop bits for the printer.
18.If the stop bit setting shown is not correct, use d and f to select the proper setting. When the value is set, press ENTER. The display should scroll to the right to read:
SERIAL1: STOPS=
19.Press f. The display should read: SERIAL1: FLOW=
20.Press g. The display should read: FLOW= setting
where setting is the default flow control setting for the printer.
21.If the flow control setting shown is not correct, use d and f to select the proper setting. When the value is set, press ENTER. The display should scroll to the right to read:
SERIAL1: FLOW=
22.Press s. The display will scroll to the left and should read: CONFIG:SERIAL1:
SERIAL I/O PORT 1 is now configured. If not using any other serial output port or any alternate host ports, the user may move to “Saving the Configuration.”
To configure SERIAL I/O PORT 0 as an output port, simply repeat this procedure for SERIAL0.
