DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506 Issue 1
April 2000
Screen reference
1014Trunk Group
17
Outgoing Rotary Dial Interdigit (msec)
This field only appears when the Outgoing Dial Type field is rotary.
Outgoing End of Dial (sec)
This field controls firmware answer supervision timers on circuit packs that have
them. It appears when the Direction field is outgoing or two-way and the Receiv e
Answer Supervision field is n. If the Receive Answer Supervision field is y, this
field does not appear and the firmware timer on the appropriate circuit pack is
automatically disabled.
NOTE:
The Answer Supervision Timeout field on the Trunk Group screen provides
timed answer supervision for circuit packs without administrable timers.
Since trunk groups may contain ports on more than one circuit pack, it’s
possible you may need to use both timers with the same trunk group. If so,
set the Outgoing End of Dial field and the Answer Supervision Timeout
field to the same value.
During a cut-through operation, timing begins after the switch sends each
outgoing digit and ceases when answer supervision is received. If the timer
expires, the switch acts as if it has received answer supervision. On senderized
operation, the timer begins after the switch sends the la st digi t coll ected. Th e timer
ceases when answer supervision is received. If t he timer ex pires, t he switch acts as
if it has received answer supervision.
Valid entries Usage
150 to 2550 in
increments of
10
Enter the minimum acceptable interval between outgoing
rotary digits. The field cannot be blank.
Valid entries Usage
1 to 254 in
increments of 1 Enter the maximum time, in seconds, that the sw itch will wait
to receive answer supervision for outgoing calls on the ports
controlled by firmware timers. For Brazil pu lsed E&M
signaling, use 40.