DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506 Issue 1
April 2000
Screen reference
578Data modules
17
When this option is enabled, the DLC reports the highest optioned speed and all
the lower speeds (or the previously selected autoadjust speed) during the
handshake process.
!CAUTION:
Caution must be used when using this option to send information from a
DTE/DCE that is transmitting data at higher rates than that of the far end.
Sustained usage of this type transmission results in loss of data. Whenever
this option is enabled, the DTE must match the highest speed selected for the
associated DLC port.
This option is intended to be used by a DTE device operating locally at a higher
baud rate than that of its far-end connection but transmitting relatively low
amounts of data (for example, a user typing at a terminal). Also, this option may
be selected whether Keyboard Dialing is selected.
NOTE:
The Low speed setting is not reported as an available speed when the Permi t
Mismatch field is y.
Dial Echoing
Appears when the KYBD Dialing field is y.
Disconnect Sequence
Appears when the KYBD Dialing field is y. Selects the sequence for a disconnect .
Valid entries Usage
y/n Enter y to instruct the DLC to operate at the highest selected
speed, which is a higher rate than the far-end data module.
Valid entries Usage
y/n Enter y to echo characters back to the DTE. Dial echoing should
be disabled when keyboard dialing is done by an intelligent
device.
Valid entries Usage
long-break A long-break is greater than 2 seconds.
two-breaks Two-breaks is within 1 second.