DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506 Issue 1
April 2000
Screen reference
607DS1 Circuit Pack
17
This field appears if the Signaling Mode field is CAS or isdn-pri. For the Japane se
2Mbit trunk circuit pack, this is a display-only field if the Signaling Mode field is
CAS.
Peer Protocol
This allows you to administer the peer level protoco l that will operate in a private
network. This field appears if the Interface field is peer-master or peer-slave. To
enter Q-SIG, the Basic Call Setup field on the System-Parameters
Customer-Options screen must be y.
Interworking Message
This field determines what message the switc h sends when an incoming ISDN
trunk call interworks (is routed over a non-ISDN trunk group).
Side
This field controls how your switch resolves glare at layer 3 over an ISDN-PRI
link in QSIG private networks. It appears if the Inter face field is peer-master or
peer-slave.
Valid entries Usage
1 to 25 Enter the country protocol used by the central office at which
this link terminates.
etsi Enter etsi if your network service provider uses the protocol of
the European Telecommunications Standards Institute (ETSI).
Enter etsi only if the Signaling Mode field is isdn-pri.
Valid entries Usage
Q-SIG This implements QSIG Network Basic Call.
TTC For private networking. Requires a Digital Trunk (Japan 2 MB
TTC) (TN2242) circuit pack.
Valid entries Usage
PROGress Normally select this value. PROGress asks the public network
to cut through the B-channel and let the caller hear tones such
as ringback or busy tone provided over the non-ISDN trunk.
ALERTing ALERTing causes the public network in many countries to
play ringback tone to the caller. Select this value only if the
DS1 is connected to the public network, and it is determined
that callers hear silence (rather than ringback or busy tone)
when a call incoming over the DS1 interworks to a non-ISDN
trunk.