Lucent Technologies 8.2

DEFINITY ECS Release 8.2

Administrator’s Guide

555-233-506 Issue 1

April 2000

Managing multimedia calling

236Multimedia Call Handling

ESM Installation

Figure Notes

Figure 11. Typical Multimedia Call handling ESM Connections

Use the following procedure and Figure 11 to connect to the ESM equipment:

1. Install the TN2207 primary rate interface (PRI) circuit pack and the TN787

multimedia interface (MMI) circuit pack in the DEFIN I TY System port

carrier.

NOTE:

These two circuit packs should be co-located in the cabinet since they

must be connected by a Y-cable on the back plane of the DEFINITY

ECS.

2. Record the circuit pack locations.

3. Connect the ESM Y-cable as shown.

4. Administer the DS1 form and the signaling-group form for the ESM (see

‘‘ESM T.120 Server Administration’’ on page 247).

5. Configure the ESM adjunct.

1. Port B Y-cable connector to a TN787

multimedia interface (MMI) circuit pack

2. Port A Y-cable connector to a TN2207

PRI circuit pack

3. 25-pair Y-cable

4. 356A adapter

5. D8W cord connected to 356A

adapter S/B port 8

6. Expansion service module

(ESM)

7. Port B on compatible primary

rate interface (PRI) card

cydf012RPY 100697