Output Fields:

Field

Description

 

 

 

 

ifname

This specifies the interface index used for the ATM Based Multi pair Bonding

 

type of interfaces. Valid Value is abond-X. Modification and deletion is not

 

possible if interface is enabled

 

 

 

GroupId

This specifies the group id configured for this interface. This field is configured

 

statically when the bonded group is provisioned and must not be changed

 

while the group is in service. These fields may be used by an operator to help

 

identify mis-configuration or to assist in management or debugging of the link.

 

 

 

MinAggrRateUpstrm

Minimum Aggregate Data Rate in bits per

second in Upstream direction.

 

 

 

MinAggrRateDnstrm

Minimum Aggregate Data Rate in bits per

second in Downstream direction.

 

 

DiffDelayTolUpstrm

The maximum differential delay among member links in a bonding group in

 

Upstream direction.

 

 

 

DiffDelayTolDnstrm

The maximum differential delay among member links in a bonding group in

 

downstream direction.

 

 

 

AsmProtocol

This parameter specifies whether Autonomous Status Messages will be

 

exchanged between CO and CPE. If it is disabled then the group would be

 

bonded statically and CO would assume CPE to know all the configuration

 

parameters like SID format, number of links in the bonded group and the links

 

participating in bonding. If it is enabled then CO would inform all these

 

parameters to CPE using Autonomous Status Messages.

 

 

SidFormat

SID Format: 8 bit or 12 bit SID. Only 8 bit format is being supported

 

 

MaxRxBitRateRatio

The maximum bit rate ratio among member links in a bonding group in

 

upstream direction.

 

 

 

LinkHecThreshold

HEC Error percentage of the link upstream rate which will act as Threshold for

 

link to be part of group in Rx direction

 

 

 

CtrlVpi

Control Channel VPI: VPI value being used for Sending and Receiving ASM

 

Messages

 

 

 

CtrlVci

Control Channel VCI: VCI value being used for Sending and Receiving ASM

 

Messages

 

 

 

NoOfLinksUpForGrpUp

This field specifies the number of links required to be up for bonding to start

 

ASM protocol

 

 

 

 

AsmIrlThreshold

IRL Threshold for ASM messages

 

 

 

 

MaxAtmPortUsRate

Maximum ATM port Upstream Rate

 

 

 

Oper Status

The actual/current state of the interface. It can be either up or down.

 

 

 

IP DSLAM

125