| of this parameter shall depend on the port type. For Net side ports, the | |||
| default value shall be disable and for the cpe side ports the default value | |||
| shall be enable. This field is unused if the bridge port is created over an | |||
| PPPOE/IPOE interface or PPPOE/ IPOE is sensed. Any value of this field | |||
| shall be ignored for a bridge port created over a PPPOE/IPOE interface. | |||
| Type: Modify － Optional | |||
|
| |||
proxyarpstatus enable | The Proxy Arp Status on this bridge port. The value enable of this field | |||
disable | indicates that Proxy Arp request can be received through this port. This | |||
| field can be enabled only on bridge port created over ethernet or | |||
| aggregator interface. Before enabling this field user should create a filter | |||
| rule with rule action as Copy to Control and rule description as | |||
| IPOE_CONTROL and map it to all those interfaces through which user | |||
| wants to receive proxy arp requests. | |||
| Type: Modify － Optional | |||
|
| |||
arptstatus Enable | This specifies whether ARP translation will be done on the ARP packets | |||
Disable | received/transmitted on this port. When enabled, ARP source MAC | |||
| address of the incoming ARP packets (both request/reply) will be changed | |||
| to virtual MAC address (if applicable) and the ARP target MAC address of | |||
| the outgoing ARP reply packets will be changed to the original host MAC | |||
| address (if applicable). | |||
| Type: | Modify | Optional | |
|
| |||
darpstatus Enable | This specifies whether the ARP packets received on this bridge port are to | |||
Disable | be directed to a single port using (VLANId, IP address) to bridge port | |||
| mapping learnt using DRA. This field can be enabled only on the NET | |||
| side bridge port. This attribute is effective in conjunction with the attribute | |||
| 'gsv dot1qVlanStaticDirectedARP' of 'Dot1qVlanStatic' MO. ARP | |||
| packets are to be directed as mentioned above, only if both the flags are | |||
| enabled. If any of the two is disabled, the ARP packets will be forwarded | |||
| as per the normal bridging flow. | |||
| Type: | Modify | Optional | |
|
| |||
porttype trusted | This field specifies whether the port is trusted or not. This information is | |||
untrusted | used by some of the control plane applications to send packet on trusted | |||
| ports, in case the application fails to uniquely determine a port. | |||
| Type: | Modify | Optional | |
|
|
|
|
|
Example:
$ create bridge port intf ifname
IP DSLAM | 185 |
|
|