table) has been reached/exceeded for the SHDSL segment endpoint. Reached/exceeded is determined by comparing the endpoint's CRC anomalies in the current 15-minute interval (as set in SHDSL End Point Curr Table) with the specified threshold.

SHDSL Loss of Sync Word Seconds 15-Minute Threshold hit: This notification indicates that the Loss of Sync Word (LOSW) seconds threshold (as set in SHDL End point alarm conf profile table) has been reached/exceeded for the SHDSL segment endpoint. Reached/exceeded is determined by comparing the endpoint's LOSW seconds in the current

15-minute interval (as set in SHDSL End Point Curr Table) with the specified threshold.

SHDSL Unavailable Seconds 15-Minute Threshold hit: This trap indicates that 15-minuteinterval threshold for SHDSL Unavailable Secondshas reached. SHDSL Invalid number of Repeaters detected: This trap indicates the

number of Invalid repeaters detected.

SHDSL Loopback Failure detected:This trap indicates that loop back failure

has been detected.

SHDSL Power Backoff Setting changed: This trap specifies that Operational

state of VDSL line has changed.

SHDSL STU-C Init Fail: This notification indicates that STUC failure during initialization due to peer STU not able to support requested configuration SHDSL Local Power Loss: This trap specifies that local power loss of SHDSL Change of OP state of SHDSL line: This trap specifies change of Operational

state of VDSL line.

SHDSL Framer OH and Defects Trap: This notification indicates a change in values of overhead/defect data transmitted from the remote unit. LOSD, SEGA, PS, and SEGD values are reported.

SHDSL STU-C Up: This trap indicates that the SHDSL STU-C is operationally up. The trap parameter is the interface name.

SHDSL STU-C Down: This trap indicates that the SHDSL STU-C is operationally down. The trap parameter is the interface name.

SHDSL Remote ATM Cell Status Response: This trap indicates that remote

ATM Cell status response has been received.

SHDSL UTC received in response of STU-R Config Request: This notification indicates the remote unit was unable to comply (UTC) with an STU-R Configuration Request -Management (EOC Message Id 18). SHDSL UTC received in response of Remote EOC request: This notification provides a generic unable to comply(UTC) indication. If the remote unit is unable to comply with a remote EOC request, this trap indicates the noncompliance of the remote unit.

SHDSL Generic Failure Trap: This notification reports any failure that has

636

IDL series User Guide