| capability is ivlcapable then svmcapable is not a valid value. If |
| the device capability is neither ivlcapable nor svmcapable then |
| the only valid value for this field is none. If the device capability |
| is ivlcapable or svlcapable then this field can't have value none. |
| ivmcapable and svmcapable can't be set together.In case of |
| Stacked Vlan Mode this shall apply to Virtual Vlans. |
|
|
Max Access | It denotes the maximum number of Access Concentrators |
Concentrators | supported. |
|
|
Max Src MAC | It denotes the maximum number of Source MAC addresses that |
Addresses | can be used across the different PPPOE and IPOE interfaces. |
|
|
Vlan Mode | Vlan Mode |
|
|
S Vlan Protocol Id | This specifies the ProtocolId value to be used for Stacked |
| Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is |
| recommended to keep the value for this different from |
| ProtocolId value defined for 802.1q Vlan(0x8100). This attribute |
| is applicable only in 'VLAN Stacking mode'. |
|
|
T Vlan Protocol Id | This specifies the ProtocolId value to be used for Stacked |
| Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is |
| recommended to keep the value for this different from |
| ProtocolId value defined for 802.1q Vlan(0x8100). This attribute |
| is applicable only in 'VLAN Stacking mode'. |
|
|
T Vlan Id | This specifies the ProtocolId value to be used for Stacked |
| Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is |
| recommended to keep the value for this different from |
| ProtocolId value defined for 802.1q Vlan(0x8100). This attribute |
| is applicable only in 'VLAN Stacking mode'. |
|
|
AbondGlbCtrlVpi | This VPI value will be used for the control channel which will be |
| created to run the ATM based multi pair bonding protocol. This |
| is a system wide parameter and applies to all the abond group |
| interfaces which can be created in the system. Change in this |
| value will be applied at next boot only. |
|
|
AbondGlbCtrlVci | This VCI value will be used for the control channel which will be |
| created to run the ATM based multi pair bonding protocol. This |
| is a system wide parameter and applies to all the abond group |
| interfaces which can be created in the system. Change in this |
| value will be applied at next boot only. |
|
|
AbondGlbSidFmt | This SID Format value will be used for all the Abond Group |
| Interfaces which can be created in the system. Change in this |
| value will be applied at next boot only. |
|
|
Ridcap | RID refers to the Routing Information Database. This database |
|
|
626 | IDL series User Guide |
|
|