Output Fields:
Field | Description |
|
|
MacAddress | The MAC address used by this bridge, when it must be |
| referred to, in a unique fashion. It is the address of one of the |
| Ethernet ports. |
|
|
No. of Ports | The maximum number of ports that can be controlled by this |
| bridge. |
|
|
Base Type | Indicates what type of bridging this bridge can perform. It is |
| always Transparent Bridging or STP. |
|
|
Aging TimeOut | The timeout period, in seconds, for aging out dynamically |
| learned forwarding information from CPEs. The value 0 can |
| be configured when aging is to be stopped. |
|
|
Slaveaging TimeOut | The timeout period, in seconds, for aging out dynamically |
| learned forwarding information learned from the slave device. |
| The recommended value for this is more than or equal to the |
| value for dot1dTpAgingTimeOut. The value 0 can be |
| configured when aging is to be stopped. |
|
|
Floodsupport | This is used to specify whether the unknown unicast packets |
| are to be flooded or not. The value for this is used along with |
| per vlan configuration for flood support to determine if |
| flooding has to be done for unknown unicast packet. |
|
|
Bcastsupport | This is used to specify whether the broadcasting is supported |
| or not. The value for this is used along with per vlan |
| configuration broadcast support, to determine if broadcasting |
| has to be done for the broadcast packet. |
|
|
Mcastsupport | Used to specify whether the multicast is supported or not. |
|
|
Mcastdrop | Used to specify whether the multicast packets are to be |
| dropped, or to be forwarded, if multicast is not supported. |
| This is only valid if dot1dTpMcastSupport is false. |
|
|
NetAgingTimeout | The timeout period, in seconds, for aging out dynamically |
| learned forwarding information from NET side port. This is |
| used only for full bridge configuration. The recommended |
| value of net aging timeout should be greater than that of |
| dot1dTpAgingTimeOut. |
|
|
Full Bridging Status | This specifies the current state of full bridging on the bridge. |
| Thebridge can be set to residential bridging, restricted full |
| bridging or unrestricted full bridging. In residential bridging, all |
| packets from a CPE side port are sent to Net side port without |
| doing a lookup in the forwarding table. In restricted full |
| bridging, there is a lookup and a packet coming from a CPE |
|
|
208 | IDL series User Guide |
|
|