decrease its transmit rate. In the case that RADSL mode is not

 

present, the value will be 0.

 

 

Upshift SnrMargin(dB/10)

Configured Signal/ Noise Margin for rate upshift. If the noise

 

margin rises above this level, the modem should attempt to

 

increase itís transmit rate. In the case that RADSL is not present,

 

the value will be 0.

 

 

Min Upshift Time(sec)

Minimum time that the current margin is above UpshiftSnrMgn,

 

before an upshift occurs. In the case that RADSL is not present,

 

the value will be 0.

 

 

Min Dnshift Time(sec)

Minimum time that the current margin is below

 

DownshiftSnrMgn, before a downshift occurs. In the case that

 

RADSL mode is not present, the value will be 0.

 

 

Fast Min Tx Rate(bps)

Configured Minimum Transmit rate for 'Fast' channels, in bps.

 

Also refer to 'adslAturConfRateChanRatio' for information

 

regarding RADSL mode and ATU-C transmit rate for ATU-R

 

receive rates.

 

 

Intl Min Tx Rate(bps)

Configured Minimum Transmit rate for 'Interleave' channels, in

 

bps. Also refer to 'adslAturConfRateChanRatio' for information

 

regarding RADSL mode and to ATU-C transmit rate for ATUR

 

receive rates.

 

 

Fast Max Tx Rate(bps)

Configured Maximum Transmit rate for 'Fast' channels, in bps.

 

Also refer to 'adslAturConfRateChanRatio' for information

 

regarding RADSL mode and to ATU-C transmit rate for ATUR

 

receive rates.

 

 

Intl Max Tx Rate(bps)

Configured Maximum Transmit rate for 'Interleave' channels, in

 

bps. Also refer to 'adslAturConfRateChanRatio' for information

 

regarding RADSL mode and to ATU-C transmit rate for ATU-R

 

receive rates.

 

 

Max Intl Delay(ms)

Configured maximum Interleave Delay for this channel.

 

Interleave delay applies only to the interleave channel and defines

 

the mapping (relative spacing) between subsequent input bytes at

 

the interleaver input and their placement in the bit stream at the

 

interleaver output. Larger numbers provide greater separation

 

between consecutive input bytes in the output bit stream, allowing

 

for improved impulse noise immunity at the expense of payload

 

latency

 

 

MSG Min Us

Configures upstream overhead channel bandwidth.This feature

 

is not supported by DSLPHY as yet.

 

 

Minimum Snr Margin(dB/10)

Atuc Configured Minimum Signal/Noise Margin. This is the Noise

 

Margin, the modem must achieve with a BER of 10 to the power -7

 

 

IP DSLAM

301