Session Id | Session Id for the session given only in case a static |
| session is being created. |
|
|
AC Mac Addr | MAC address of the remote AC given only in case a static |
| session is being created. |
|
|
Mac Addr Prof | Profile Id for self MAC addresses. The profile for the same |
| is created using the PPPoEMacAddrProfileTable. |
|
|
Service Name Profile | Profile Id related to Service Name for the Session based on |
| which the AC is selected.The Profile for the same is |
| created using the PPPoESessionProfileTable. A value of |
| "any" means no specific service is needed to select an AC. |
| A value of "anyconfigured"means any configured service |
| name profile can be used for selecting an AC. |
|
|
AC Name Prof | Profile Id related to AC Name for the Session based on |
| which the AC is selected. The Profile for the same is |
| created using the PPPoEAcProfileTable. A value of "any" |
| means no specific AC is needed for establishing a session |
| on the WAN side. A value of "anyconfigured"means any |
| configured AC name profile can be used for selecting an |
| AC. |
|
|
Eth Pkt Type | This specifies the type of the packet. |
|
|
Nature | Specifies if the interface is dynamic or static in nature. The |
| session is assumed to be in established state when the |
| interface is static in nature. |
|
|
Oper Status | The actual/current state of the interface. It can be either up |
| or down. |
|
|
Admin Status | The desired state of the interface. It may be either Up or |
| Down. |
|
|
References:
zPPPoE session config related commands.
IP DSLAM | 505 |
|
|