together. In case Iftype is ‘slave’, then this field can not be

 

set to GS_TRUE.

 

 

Ip Address

This parameter specifies the IP address configured for the

 

interface. This is required to be configured only if this

 

interface is used for management IP traffic. If it is not

 

configured and 'etherUseDhcp' is configured as

 

GS_FALSE, then management IP traffic will not flow

 

through this interface. ‘Modify’ of IP Address for an Ethernet

 

interface shall be supported only if some IP address is

 

configured on the interface or 'etherUseDhcp' was

 

configured to "GS_TRUE" previously. If Usedhcp is

 

GS_TRUE and ‘modify’ is done for this field, then Usedhcp

 

field shall be set to GS_FALSE. Both ‘Usedhcp’ and this

 

field shall not be specified together.

 

 

Mask

This parameter specifies the network mask configured for

 

the interface. This is given in conjunction with IP Address

 

configured and shall be given only if IP address has been

 

given. This shall be removed whenever IP Address is

 

removed. ’Modify’ of network mask for an Ethernet interface

 

shall be supported only if some IP address is configured on

 

the interface or 'etherUseDhcp' was configured to

 

"GS_TRUE" previously. If Usedhcp is GS_TRUE

 

and ’modify’ is done for this field, then usedhcp field shall

 

be set to GS_FALSE. Both usedhcp and this field shall not

 

be specified together.

 

 

pkttype

This parameter defines the packet type supported by the

 

interface. ‘etherPktTypeSupported’ shall be configured for

 

every Ethernet interface. By default, all packets will be

 

transmitted. The interface shall not transmit any other

 

packet type than that configured.

 

 

Orl

This parameter specifies the output rate limiting value to be

 

applied on this Interface.The units for the same is in

 

Mbits/sec

 

 

Configured Duplex

The duplex mode to be used by the interface, as configured

 

by the user.

 

 

Duplex

This parameter defines the modes, in which the Ethernet

 

Interface can come up. It can be configured as ‘auto’, ‘half’,

 

‘full duplex’ or a combination of these. Based on the values

 

configured, the Ethernet interface negotiates with the peer

 

entity.

 

 

IP DSLAM

325