base ADSL2 depending upon the downstream rate. It is avaiable

 

only for ADSL2 Annex A.(length = 4 bytes)

 

 

Max Nom PSD(dB/10)

This parameter specifies the maximum nominal transmit

 

PSD(MAXNOMPSD) level during initialization and showtime.

 

Value depends on CO MIB element settings and near end

 

transmitter capabilities and is exchanged in the G.994.1 Phase. It

 

is available only for ADSL2/ADSL2plus. Value ranges from -60 to

 

-40 in steps of 0.1 dBm/Hz.(length = 4 bytes)

 

 

Max Nom AtpPsd(dB/10)

This parameter specifies the maximum nominal aggregate

 

transmit power(MAXNOMATP) level during initialization and

 

showtime. Value depends on CO MIB element settings and local

 

capabilities and is exchanged in the G.994.1 Phase. It is available

 

only for ADSL2/ADSL2plus. Value ranges from 0 to 25.5 in steps

 

of 0.1 dBm.(length = 4 bytes)

 

 

DS PSD Mask

This configuration parameter defines that the downstream PSD

 

mask applicable at the U-C2 reference point. This MIB PSD mask

 

may impose PSD restrictions in addition to the Limit PSD mask

 

defined in the relevant Recommendation (e.g., G.992.5). (length =

 

4 bytes).

 

 

GsAnnexCOlToCxSwitch

Conexant parameter that is used to configure the switching point

 

between DBM-OL and XOL.(length = 4 bytes)

 

 

GsAnnexCSwitch

Conexant parameter that is used to configure the switching point

 

between Annex C and G.Span (IFM) and between Annex C and

 

G.Span Plus.(length = 4 bytes)

 

 

GsAnnexCToUqSwitch

Conexant parameter that is used to configure the switching point

 

between Annex C and G.Span Plus SUQ.(length = 4 bytes)

 

 

Min SnrMgnTime(sec)

This parameter indicates the time when the snr margin violation is

 

allowed. After this time expires and current snr is less than min

 

snr, the DSL line is dropped by the APIs.

 

 

Customer ID

This parameter indicates the customer ID.

 

 

GsMPsdMaskType

Conexant parameter that selects the PSD mask option to be used

 

for Adsl2M.

 

 

GsSeltLoopGauge

This parameter should be set to the expected loop gauge.

 

 

Rate Ratio

This parameter specifies the latency rate for both channels in a

 

dual latency configuration. This parameter must be set the

 

parameter to a value greater than 0 and less than 100.

 

 

Target Snr Margin(dB/10)

Noise Margin the modem must achieve with a BER of 10 to the

 

power 7 or better to successfully complete initialization

 

 

Dnshift SnrMargin(dB/10)

Configured Signal/ Noise Margin for rate downshift. If the noise

 

margin falls below this level, the modem should attempt to

 

 

300

IDL series User Guide