Planet Technology IDL-2400, IDL-2401, IDL-4800, IDL-4801 manual 288

aturintlmaxtxrate	Configured Maximum Transmit rate for 'Interleave' channels, in bps.
<aturintlmaxtxrate-val>	Also refer to 'adslAturConfRateChanRatio' for information regarding
	RADSL mode and to ATU-C transmit rate for ATU-R receive rates.
	Type:	Modify	--	Optional
	Valid values: 0 - 0xffffffff
aturmaxintldelay	Configured maximum Interleave Delay for this channel. Interleave
<aturmaxintldelay-val>	delay applies only to the interleave channel and defines the mapping
	(relative spacing) between subsequent input bytes at the interleaver
	input and their placement in the bit stream at the interleaver output.
	Larger numbers provide greater separation between consecutive input
	bytes in the output bit stream, allowing for improved impulse noise
	immunity at the expense of payload latency
	Type:	Modify	--	Optional
	Valid values: 0 - 0xffffffff
databoost Enable Disable	Conexant parameter that enables/disables DataBoost option.
	Type:	Modify	--	Optional
upstreampsd Extended	Conexant parameter that sets the upstream PSD to be either
Standard Jj100	extended or standard. Used for GSpan Plus only.
	Type:	Modify	--	Optional
atucconfpmmode	PM-related parameter used by the ATU-C to set the allowed link states.
pmstatel3enable	Both bit values can be given simultaneously in the input. Additional
pmstatel2enable disable	value to disable pmmode is disable, which is equal to 0.
	Type:	Modify	--	Optional
atucconfpml0time	PM configuration parameter, related to the L2 low power state. This
<atucconfpml0time-val>	parameter represents the minimum time (in seconds) between an exit
	from the L2 state and the next entry into the L2 state. It ranges from 0 to
	255 seconds.
	Type:	Modify	--	Optional
	Valid values: 0 - 255
atucconfpml2time	PM configuration parameter, related to the L2 low power state. This
<atucconfpml2time-val>	parameter represents the minimum time (in seconds) between an Entry
	into the L2 state and the first Power Trim in the L2 state and between
	two consecutive Power Trims in the L2 State. It ranges from 0 to 255
	seconds.
	Type:	Modify	--	Optional
	Valid values: 0 - 255
atucconfpml2atpr	PM configuration parameter, related to the L2 low power state. This
<atucconfpml2atpr-val>	parameter represents the maximum aggregate transmit power
	reduction (in dB) that can be performed through a single Power Trim in
	the L2 state. It ranges from 0 dB/10 to 310 dB/10.

288 IDL series User Guide