
IGMP type comparison | IGMP type comparison type |
|
|
Igmp code | This field specifies the Max Response Code (time) fields of |
| IGMP packet. This field is invalid if igmphCodeCmpType is |
| any. |
|
|
IGMP code comparison | IGMP code comparison type |
|
|
Start group address | Start group address of the range of igmp group addresses.This |
| field is invalid if 'igmpgroupaddrcmp' is 'any'. This field and |
| 'groupaddrto' specify a range of IGMP group addresses, if |
| 'igmpgroupaddrcmp' is either 'inrange' or 'exrange' |
|
|
End group address | End group address of the range of igmp group addresses. This |
| field and 'groupaddrfrom' specifiy a range of IGMP group |
| addresses, if 'igmpgroupaddrcmp' is either 'inrange' or 'exrange' |
|
|
IGMP group address | IGMP group address comparison type |
comparison |
|
|
|
Subrule Priority | This specifies the priority of the subrule. Based on this priority |
| value, the subrule is created in fast or slow memory. In case |
| priority is specified as 'asinrule', subrule priority will be same as |
| specified in the rule. |
|
|
Transport Header | This specifies the type of the transport header in the packet in |
| which the corresponding IP is being transported. If the value of |
| this field is Ethernet(0x1), then the IP is being carried in the |
| ethernet header. If it is pppoe(0x2), then the corresponding IP is |
| being carried in the PPP header. |
|
|
References:
zGeneric Filter commands
5.13.32Filter subrule IP Commands5.13.32.1 Get Filter subrule ipDescription:
Use this command to get.
Command Syntax:
get filter subrule ip [ruleidIP DSLAM | 429 |
|
|