this node, in units of seconds.

 

 

Br Max Age(Sec)

The maximum age of Spanning Tree Protocol information learned

 

from the network on any port before it is discarded, in units of

 

seconds, when this bridge is the root of the spanning tree. Note

 

that IEEE-802.1D specifies that the range for this parameter is

 

related to the value of dot1dStpBridgeHelloTime.

 

 

Curr Max Age (Sec)

The maximum age of Spanning Tree Protocol information learned

 

from the network on any port before it is discarded, in units of

 

seconds. This is the actual value that this bridge is currently

 

using.

 

 

Br Hello Time(Sec)

The value that all bridges use for HelloTime when this bridge is

 

acting as the root.

 

 

Curr Hello Time(Sec)

The amount of time between the transmission of Configuration

 

bridge PDUs by this node on any port when it is the root of the

 

spanning tree or trying to become so, in units of second. This is

 

the actual value that this bridge is currently using.

 

 

Br Fwd Delay(Sec)

The value that all bridges use for ForwardDelay when this bridge

 

is acting as the root. Note that IEEE-802.1D specifies that the

 

range for this parameter is related to the value of

 

dot1dStpBridgeMaxAge.

 

 

Curr Fwd Delay (Sec)

This is the actual time value, measured in units of seconds,

 

controls how fast a port changes its spanning state when moving

 

towards the Forwarding state. The value determines how long the

 

port stays in each of the Listening and Learning states, which

 

precede the Forwarding state. This value is also used, when a

 

topology change has been detected and is underway, to age all

 

dynamic entries in the Forwarding Database.

 

 

STP status

Spanning Tree Protocol to be enabled on the Bridge or not.

 

Spanning Tree Protocol can not be enabled in Stacked Vlan

 

mode.

 

 

References:

zget stp info command

zstp port related commands.

IP DSLAM

201