
Parameters:
Name | Description |
|
| |
|
|
|
|
|
ifname ifname | This specifies the aggregator interface index on which active standby is to be | |||
| enabled. Valid Value is | |||
| Type: | Modify | Mandatory | |
|
| Get | Optional | |
| Valid values: |
| ||
|
| |||
Status | This specifies whether active standby mode is to be enabled or not. | |||
enable disable | Type: | Modify | Optional | |
|
|
|
|
|
Example:
$ get actstdby aggr info IfName
Output:
Interface Index :
Status : Enable
Output Fields:
Field | Description |
|
|
Interface Index | This specifies the aggregator interface index on which |
| active standby is to be enabled. Valid Value is |
|
|
Status | This specifies whether active standby mode is to be |
| enabled or not. |
|
|
zActive Standby mode shall not be enabled, if aggregator interface and redundancy aggregator are not created, or if LACP aggregator is created for the aggregator interface.
zIf only Active Standby is desired and no load sharing is expected then bridge port shall be created over the aggregator only after Active Standby has been enabled for redundancy aggregator. If the bridge port is created over aggregator before enabling Active Standby for it, the load sharing shall start and continue till Active Standby is enabled.
References: Redundancy commands.
IP DSLAM | 133 |
|
|