Last Change | The value of sysUpTime at the time this VC entered its current operational |
| state. |
|
|
MgmtMode | It denotes the Management Mode of the ATM VC. If it is Data, then only |
| data transmission can take place. If it is Mgmt, then management of |
| remote CPE device can happen on that ATM VC and packets on that ATM |
| VC shall start coming to Control Plane. In DataAndMgmt mode, data |
| transmission as well as remote CPE management can happen on the |
| same ATM VC interface. In DataAndMgmt mode, the only acceptable |
| value for atmVCCAAL5EncapType is llc. In Mgmt mode, EoA interface |
| can't be created on the ATM VC and both Ethernet as well as |
| packets on that ATM VC shall be received at Control Plane. In |
| DataAndMgmt mode, if EoA is created then only |
| that ATM VC shall be received at Control Plane. However, if EoA is not |
| created then all the packets on that ATM VC shall be received at Control |
| Plane. However, to configure ATM VC in DataAndMgmt mode, good |
| practice is to create ATM VC in disable mode till EoA is created on it, to |
| prevent flooding at Control Plane. In order to run STP, the mode has to be |
| DataAndMgmt. If the mode is RawATM(4), ATM cells are given to |
| Control Plane. In this mode, EoA interface cannot be created on the ATM |
| VC. If EoA interface is already created on the ATM VC, its mode cannot be |
| changed to either Mgmt(2) or RawATM(4). This field is not valid if |
| encaptype is Ethernet. |
|
|
RowStatus | This defines the |
|
|
VC Type | This field specifies whether VC type is PVC or SVC. |
|
|
VC Topology | This field specifies the VC connection topology type. |
|
|
Max simultaneous | This field specifies the maximum number of simultaneous active protocol |
protocol | stacks supported on this interface. Currently, only one protocol stack is |
| supported. |
|
|
Auto Status | This field specifies whether the Auto mode is to be enabled or not. In the |
| Auto mode, the stack above this interface will be determined and created |
| based on the protocol packets sensed on this interface. For example, if the |
| protocol packet sensed above this interface is an EoA packet, then the |
| corresponding EoA stack will be created above this interface. However, |
| the corresponding EoA interface must have been created with the |
| gsvEoaConfigMode field's bit corresponding to the 'Auto' set. |
|
|
Auto Supported | This field specifies Higher layer protocols which are supported for auto |
Protocol | detection on the given ATM VC. Only the packets if the protocols |
| mentioned in this field can lead to Auto detection. This field is meaningful |
| only when autostatus flag is enable. |
|
|
Auto VC Mux Forced | This field specifies if the encap type detected is VCMux, the user can |
|
|
IP DSLAM | 169 |
|
|