Output Fields:

FIELD

Description

 

 

Ifname

The PPPR interface.

 

 

Low IfName

This specifies the name of the lower AAL5

 

interface.

 

 

Max PDU Size

This specifies the maximum PDU size on a PPPR

 

interface.

 

 

Ter Ack TimeOut

Time in seconds to wait for LCP terminate Ack,

 

after sending a terminate request.

 

 

Lowif Toggle TimeOut

Time in seconds to wait for lowif to come up

 

without tearing down the pppr session.

 

 

Nature

Specifies if the interface is dynamic or static in

 

nature.

 

 

Config Status

This mode describes the configuration status for

 

the interface. If the "config" bit is set, this interface

 

shall be created, but will have a dormant status.

 

Only after the receipt of an pppoa packet from the

 

CPE side, this interface shall become active. The

 

"In-Use" and "Not-In-Use" bits are read-only bits.

 

The "Not-In-Use" bit indicates that the entry is

 

dormant and "In-Use" bit indicates that the entry is

 

activated.

 

 

Operational Status

The actual/current state of the interface. It may be

 

either Up or Down.

 

 

Admin Status

The desired state of the interface. It may be either

 

Up or Down.

 

 

PPPOA PacketsPrio

Priority to be set in tagged PPPOE frames or PPP

 

packets sent over this port from Control

 

Plane .This priority shall also be used for choice of

 

traffic class/ Queue on outgoing interface whether

 

the frame is tagged or not.In case the bridge port is

 

over an Aggregated ATM VC, this will also be

 

used to identify the VC, on which the packet is to

 

be sent.

 

 

IP DSLAM

511