
| Field | 
 | Definition | 
| DSL Port | 
 | Port No. of the IP DSLAM | 
| VPI | 
 | Virtual Path Identifier | 
| VCI | 
 | Virtual Channel Identifier | 
| 
 | 
 | The state of learning on this bridge port. The value enable (1) | 
| Learning Status | 
 | indicates that unicast Mac address learning is enabled and the | 
| 
 | value disable indicates that unicast Mac address learning is | |
| 
 | 
 | |
| 
 | 
 | disabled on this bridge port. | 
| 
 | 
 | 
 | 
| 
 | 
 | Indicates if the port has been set as sticky. The value enable (1) | 
| 
 | 
 | indicates that the entries learned on this port will not be aged out. | 
| Sticky Status | 
 | It also indicates that the entries learned on this port shall not be | 
| 
 | learned on any other port. The entries learned on this port can | |
| 
 | 
 | |
| 
 | 
 | only be removed by management action or by making the value | 
| 
 | 
 | as disable (2), so that the entries can be aged out. | 
| Pvid | 
 | Port VID | 
| Accepted Frame Type | 
 | Used to up/down connection. | 
| Ingress Filter | 
 | When this is true, the device will discard incoming frames for | 
| 
 | VLANs, which do not include this Port in its Member set. When | |
| 
 | 
 | false, the port will accept all incoming frames. | 
| Priority | 
 | Optional Connection priority. No VLAN tag, no priority. | 
a. Choose the port to configure from the DSL Port 
b. Configure the Administration status as “Up” or “Down”.
c. Choose a Line Profile from the Line Profile Name 
Line Profile, Click on  to activate the Line Profile Configuration window.
 to activate the Line Profile Configuration window.
d. Choose an Alarm Profile from the Alarm Profile Name 
an Alarm Profile, Click on  to activate the Alarm Profile Configuration window.
 to activate the Alarm Profile Configuration window.
If necessary, modify values of specified PVC, including VPI, VCI, Admin Status, Learning Status, Sticky Status, Pvid, Accepted Frame Type and Ingress Filter, and priority.
e. Click on  to submit or click on
 to submit or click on  to close the fmBridgeport window.
 to close the fmBridgeport window.
f. If to create new PVC, click on  and then PVC2 appears and then users can
 and then PVC2 appears and then users can
set perimeters via PVC2. after that, click on  to submit your setting.
 to submit your setting.
| 68 | IDL series User Guide | 
| 
 | 
 |