EthType | This specifies the Defines the ethernet types – data | |
, mgmt, or both. It is a bitmask. | ||
| ||
|
| |
Num of LBRams | This specifies the number of LBRams in the system. | |
|
| |
Num of Chips | This specifies the number of Chips in the system. | |
|
| |
Num of Ports | This specifies the number of Ports per Chip in the system. | |
|
| |
Interface Type | This specifies the InterfaceType. Following are the values it | |
can take – Host Bus, PCI, Utopia | ||
| ||
|
| |
Chip Type | This specifies the Type of Chip – G24, G16, and octane. | |
|
| |
Serial Number | This specifies the vendor specific string that identifies the | |
vendor equipment. | ||
| ||
|
| |
Vendor Id | This specifies the binary vendor identification field. | |
|
| |
Version Number | This specifies the vendor specific version number | |
sent by this ATU as part of the initialization message | ||
| ||
|
| |
Base Addr | This specifies the base address of the chip. | |
|
| |
LBRam | This specifies the LBRam associated with the chip | |
|
| |
Logical To Physical | This specifies the Logical To Physical Port Mapping. | |
Port Mapping | ||
| ||
|
| |
No of UARTs | This specifies the number of UARTs configured. | |
|
| |
HSSL Port Id | This specifies the HSSL port to be used for UART. | |
|
| |
Baud Rate | This specifies the Baud Rate of the port | |
|
| |
Data Bits | This specifies the number of data bits to be used | |
|
| |
Stop Bit | This specifies the stop bits used on HSSL – 1, 2, 1.5 | |
|
| |
Parity | This specifies the parity used on HSSL – even, odd, none | |
|
| |
UART Mode | This specifies the UART Mode – polling, interrupt based | |
|
| |
Application Type | This specifies the application name using this UART. | |
|
|
Description:
This command is used for displaying a list of reboot failures that were encountered when the system was trying to come up.
Command Syntax:
get system reboot info [numentries]616 | IDL series User Guide |
|
|