is only used to sense the llc/vcmux. Atm VC with encaptype as ethernet

 

can be created only over an ATM port which has value of

 

atmtransporttype as packet.The VPI/VCI values for this atm vc shall be

 

0/0. aaltype, mgmtmode and oam related parameters are not valid for

 

an ATM VC with encaptype as Ethernet.

 

Type: Optional

 

Default Value: llcmux

 

 

Pvc

This specifies the type of VC. The only value supported is PVC.

 

Type: Optional

 

Default Value: pvc

 

 

channel

This extension specifies the type of channel on which the ATM VC's

fastinterleaved

cells have to be transmitted/ received. This field is deprecated and

 

currently not in use.

 

Type: Optional

 

Default Value: Interleaved

 

 

Maxnumproto

This field specifies the maximum number of simultaneous active

<maxnumproto-val>

protocol stacks supported on this interface. Currently, only one protocol

 

stack is supported.

 

Type: Create Optional

 

Default value: 1

 

 

Autostatus

This field specifies whether the Auto mode is to be enabled or not. In

EnableDisable

the Auto mode, the stack above this interface will be determined and

 

created based on the protocol packets sensed on this interface. For

 

example, if the protocol packet sensed above this interface is an EoA

 

packet, then the corresponding EoA stack will be created above this

 

interface. However, the corresponding EoA interface must have been

 

created with the config status field set as config mode. This field is not

 

valid if encaptype is Ethernet.

 

Type: Create Optional

 

Default value: disable

 

 

autosupportedprot

This field specifies Higher layer protocols which are supported for auto

none{pppoa eoa

detection on the given ATM VC. Only the packets if the protocols

ipoa}+

mentioned in this field can lead to Auto detection. This field is

 

meaningful only when autostatus flag as enable.

 

Type: Create Optional

 

Modify Optional

 

Default value: 1

 

 

autovcmuxforcedprot

This field specifies that if the encap type detected is VCMux, the user

None pppoa eoa

can configure to build a specific protocol stack automatically. It can only

ipoa

be present with the autostatus flag as enable. In case of a conflict with

 

 

166

IDL series User Guide