be set to true only if encaptype of the lower interface is

 

Ethernet.

 

 

Pkt Type

This parameter defines the packet type supported by the

 

interface. ‘EoAPktTypeSupported’ shall be configured

 

for every CPE side Ethernet interface. By default, the

 

option taken is 'ALL' and it means that all packets will be

 

transmitted. The value 'None' means that normal Ucast

 

packets will be transmitted. The interface shall not

 

transmit any other packet type than the ones configured.

 

 

Admin Status

The desired state of the interface. It may be either Up or

 

Down

 

 

Oper Status

The actual/current state of the interface. It can be either

 

up or down.

 

 

InActivity Tmr Interval

This field specifies the time (in seconds) after which

 

interfaces shall be marked inactive if there is no data

 

activity on this interface during this interval. This is used

 

only when the bit corresponding to "ConfigEntry" is set

 

for gsvEoaConfigStatus field. A value of zero means the

 

timer is not running. In Aautosensing scenario, an

 

inactive interface is a candidate to deletion in case

 

another protocol is sensed on Atm Vc Interface on which

 

this interface is created.

 

 

Config Status

This parameter describes the configuration mode for this

 

interface.The value of this parameter can be Normal,

 

Config, NotInUse, or InUse. If the value is Config, then

 

this interface shall be created, but will have a dormant

 

status. Only after the receipt of an EoA packet from the

 

CPE side, this interface shall become active. The 'InUse'

 

and 'NotInUse' bits are read-only bits. The 'NotInUse' bit

 

indicates that the entry is dormant and the 'InUse' bit

 

indicates that the entry is activated.

 

 

M2VMac Database Id

This field specifies the M2VMac Database Id associated

 

with this interface. The value 0 means Virtual MAC

 

feature is disabled on this interface. This field can be

 

modified only when the interface is disabled.

 

 

References:

zEthernet commands

zEthernet Stats commands.

IP DSLAM

331