Parameters:
Name | Description |
|
|
ifname | The IPOE Tunneling Interface. |
Type: Create － Mandatory | |
| Delete － Mandatory |
| Modify － Mandatory |
| Get － Optional |
| Valid values: |
|
|
lowif | This specifies the lower interface index.It contains the ifindex |
| of the IPoA interface. |
| Type: Create － Mandatory |
| Valid values: 0 － 575 |
|
|
macaddrprof | Profile Id corresponding to the MAC address assigned to this |
macaddrprof | IPOE interface. This Profile is created using the |
| MacAddrProfileTable. |
| Type: Create － Mandatory |
| Modify － Optional |
| Valid values: 1 |
|
|
ethpkttype Type2 | This specifies the type of the Packet. |
802_3 | Type: Create － Optional |
| Modify － Optional |
| Default value: Type2 |
|
|
inactivitytmrintrvl | This field specifies the time (in seconds) after which |
inactivitytmrintrvl | interfaces shall be marked inactive, if there is no data activity |
| on this interface during this interval. This is used only when |
| the bit corresponding to "ConfigEntry" is set for |
| gsvIpoeConfigStatus field. A value of zero means the timer is |
| not running. In autosensing scenario, an inactive interface is |
| a candidate to deletion, if another protocol is sensed on Atm |
| Vc Interface on which this interface is created |
| Type: Create － Optional |
| Modify － Optional |
| Valid values: 0- 0xffffffff |
| Default value: 0 |
|
|
routingstatus enable | This specifies if the IP Routing Lookup has to be done for this |
disable | interface. By default, for the downstream traffic destined for |
| IPOE interface, IP lookup is done based on the downstream |
| route configured for the IPOE interface.If iproutingstatus is |
| disabled, layer 2 lookup shall be used instead, for forwarding |
| the downstream traffic for this IPOE interface. |
|
|
IP DSLAM | 479 |
|
|