AltiGen comm ACM 5.1 Configuring the Triton T1/E1 Board, Configuring the Board, Configuration

Chapter 11: Board Configuration

Configuration

Double-click the TritonIP board in the Boards window to open the Board Configuration window, similar to Figure 2 on page 124. See attribute descriptions below Figure 2. Note the following additional information:

•Clicking the Board Configuration button opens a window that displays the board serial number, DSP clock, and physical and logical IDs. The drop-down list in the Configure Type field lets you select between a 12-port G.711/G.723/G.729 configuration and a 30-port G.711 configuration.

If you change this configuration, you must restart the switching services for the change to take effect.

Figure 5. Board Configuration window

Configuring the Triton T1/E1 Board

Overview of the Triton T1/E1 Board

Through AltiWare Administrator, the Triton T1/E1 board can be configured for either digital T1 CAS (channel associated signaling), T1 PRI (Primary Rate Interface), E1 CAS, or E1 PRI.

Both T1 CAS and T1 PRI carry 24 channels using time-division multiplexing (TDM) at an overall rate of 1.544 Mbps. Voice T1 provides 24 64K channels with robbed bit signaling. T1 PRI provides 23 64K channels, using one 64K channel for D channel messaging.

E1 CAS and E1 PRI carry 32 channels using TDM at an overall rate of 2.048 Mbps. Both of them provide 30 64K channels for voice.

To subscribe to T1 CAS, T1 PRI, E1 CAS, or E1 PRI service, you must supply certain parameters. These parameters are listed in Appendix B on page 419.

Configuring the Board

Double-click the Triton T1/E1 board in the Boards window to open the Board Configuration window, similar to Figure 2 on page 124. See attribute descriptions below Figure 2. Note the following additional information:

•The Board ID must be in the range 0–7.

•Double-click a channel in the Channel Mapping List to open a trunk configuration dialog box.

•Double-click a channel group to open a configuration window, discussed in the following section.

•Clicking the Board Configuration button opens a configuration dialog box that displays the board’s serial number, DSP clock, physical and logical IDs.

128AltiWare ACM 5.1 Administration Manual