AltiGen comm ACM 5.1 Triton T1/E1 Trunk Properties, Dialing Delay, Caller ID and did Collection

Chapter 12: Trunk Configuration

Triton T1/E1 Trunk Properties

To open a configuration dialog box for a Triton T1/E1 channel, do one of the following:

•If you’re in the Trunk Configuration window, select a Triton T1/E1 channel from the trunk channels list, then click the Trunk Properties button, or just double-click the channel in the list.

•If you’re in the Trunk View window, right-click the channel and select Channel Properties.

Figure 6. Triton T1 Configuration dialog box

Following are the parameters for the Triton T1 Configuration dialog box:

Parameter	Description
T1 robbed-bit signaling
Protocol	You can set Protocol to one of the following:
	• E&M Wink Start (default)
	•	E&M Immediate Start
	•	Ground Start
	•	Loop Start
	For signaling from one board to another, only E&M Wink
	Start is supported. Loop Start, Ground Start, and E&M
	Immediate Start protocols cannot be used for interfacing
	between two boards.
Dialing Delay	Specifies the delay, in milliseconds, after trunk seizure and
	before digit dialing. This configuration will slow down the
	system transmitting digits to the CO by a defined delay to
	avoid missing digits. Do not change this value unless advised.

Caller ID and DID Collection

AltiWare ACM 5.1 Administration Manual 157