AltiGen comm ACM 5.1 Max. seconds, Before the first, Digit, Between digits, Incoming, Sequence

Chapter 12: Trunk Configuration

Parameter Description

You can select the maximum time-out delays, in seconds, and the appropriate sequence of symbols to be collected for Caller ID and DID.

Max. seconds	Maximum wait time before time-out for the system to identify
before the first	this digit after either the first ring in ground start or loop start
digit	or the wink in wink start. The range is from 1-6 seconds, or
	None, with a default value of 3 seconds. Do not change this
	value unless advised.
	None means no Caller ID or DID information will be collected.
	All other options will be grayed out. Use this option to disable
	Caller ID and DID collection.
Max. seconds	Maximum wait time before time-out between two digits.
between digits	Default value is None. Do not change this value unless
	advised.
	Selecting None means the system will only wait for the
	sequence of digits that are collected within the length of time
	specified in the Max. seconds before the first digit field.
Incoming	Select up to five incoming symbols to collect from the Caller
sequence	ID or DID digits:
	•	None
	•	#
	•	*
	•	# or *
	•	Caller ID
	•	DID/DNIS
	Selecting None in any field of the sequence will terminate the
	sequence and automatically disable subsequent entries in the
	sequence.
	The default sequence is:
	“# or *” (and then) “Caller ID” (and then) “# or *” (and then) “DID/
	DNIS”
Or	Sets up an additional, alternative sequence. You can select
	another set of up to five incoming symbols to collect.
	Not checking any box is equivalent to checking None in the
	first field.
	The default sequence is:
	“DID/DNIS”
Apply to	If appropriate, you can use this button, as described in
	“Configuring One or Multiple Trunks” on page 150, to apply
	the Caller ID Collection to multiple T1 trunks.

Note: In order for back-to-back T1 and tie trunk T1 configurations to perform properly, it is recommended that you use the system’s default incoming call sequences:

158AltiWare ACM 5.1 Administration Manual